Profiles

Covering profiles

We offer you a range of high-quality covering profiles to give your entrance a marvellous appearance. These finishing profiles are also often used when the installation of the mat requires a large number of saw cuts that you would like to cover.

As we can also bend these profiles they are also suitable for revolving doors or turning stiles.

We offer you a range of high-quality covering profiles to give your entrance a marvellous appearance. These finishing profiles are also often used when the installation of the mat requires a large number of saw cuts that you would like to cover.

As we can also bend these profiles they are also suitable for revolving doors or turning stiles.

Click on image to enlarge

Frames

A frame is a very interesting option if an entrance must still be built. This allows the mat to be sunken a few millimetres into the ground, whereby the top of the mat becomes level with the ground.

The frame usually consists of four profiles that have been cut diagonally and attached to each other with screws or anchors. The entire frame can be installed before the concrete is poured, but can also be attached to the concrete afterwards. As the well and the frame must be entirely finished before the installation of the entrance mat, it is recommended to order the frame in advance. We will be happy to deliver the entrance mat a little later.

Our framework is available in 4 different heights. The advantage of our profiles is that two different heights are processed in one profile. This means that even if the depth of the well is slightly changed at the very last moment our profile can be placed anyway due to its flexibility. The aluminium of the two profiles is anodized.

Click on image to enlarge

Sloping profiles

The ABI entrance mat program is renowned for its cleaning ability, durability and excellent appearance. When a mat has not been sunken or placed in a mat well, it is recommended to fit an angle edge profile, which makes it easier for wheel chairs, walkers and prams to enter your premises.

If the Sloping profile is fitted to the approach side of the mat, then the mat can still be rolled up. Sloping profiles can also be delivered as a set. The mat gets closed off on three sides, with the fourth side against the entrance. In that case, the three profiles are cut diagonally and then by screwing the profiles to the ground, the mat can still be rolled up.

The Sloping profiles are available in two different heights. The lowest profile is made from aluminium brut. The aluminium of the higher version is anodized.

Click on image to enlarge

T-profiles

When the cutting of a mat is required to make sure that the mat is not too heavy or wide, T-profiles are used.
The cutting of the mat is done in consultation with the client. The mat may be cut in two, three or even more parts, depending on the width and design of the entrance. A T-profile is then placed between the parts, thus ensuring an excellent appearance of the mat.

Our T-profiles are available in three different heights, 10 mm, 14 mm and 17 mm so that any selected ABI mat has a T-profile to go with it. All three heights are made in brut aluminium.

Click on image to enlarge